No P Trap In Shower Drain. Remove the vanity from the wall or the vanity shelf (if possible) and cut out the marked rectangle with a saw. The sealant will prevent water from soaking into.
A previous owner did some remodeling and the shower drain pipe is plumbed right into the top of the waste line with a tee. Remember, the stickiness of primers only lasts for ten to fifteen seconds. Make sure you cut an even 12” by 12” square piece, and that you only cut the portion that runs over the floor boards.
So, You Will Have To Be Very Fast In Spreading The Primer And Then Merging The Two Parts.
If nobody uses the bathtub or shower often. The trap needs to be as close to the drain as possible, it should not be run 2ft. One option is to use a diverter valve.
Remove The Trap And Draw The Rectangle That You Have To Cut Out.
A previous owner did some remodeling and the shower drain pipe is plumbed right into the top of the waste line with a tee. Measure out a piece of abs piping equal to that distance, and cut it. All fixtures need a trap!!
Shacko | Apr 06, 2007 06:28Pm | #2.
To begin, start by cutting the subfloor around the drain with an electric saw. Remember, the stickiness of primers only lasts for ten to fifteen seconds. Smooth the edges with sandpaper and apply two coats of waterproof sealant on the edges.
So, This Is The Approximate Space You.
The sewer system that could cause you a major health issue!, fix this as fast as possible! Pour a half gallon of water in the shower drain and see if that stops the odor. This will cause a vapor lock, drains require air to push the fluid down and 2 traps in the same line will eliminate this and cause a lot of problems.
The Sealant Will Prevent Water From Soaking Into.
This step ensures a precise cut. If you have a snake it can be used to tell if there is a trap on the line. The minimum room for a p trap shower is a maximum of 2 inches if you are installing it for the first time.
Post a Comment for "No P Trap In Shower Drain"